The effect of sewage effluent on the permeability of soil

 

Table Of Contents


  • <p> <strong>

Chapter ONE

INTRODUCTION

  • .<br>
  • 1.1Definition of terms<br>1.
  • 1.1Permeability<br>1.1.
  • 2.Sewage effluent<br>1.1.
  • 3.Compaction<br>1.1.
  • 4.Failure<br>1.
  • 2.Aims and objectives<br>1.
  • 3.Scope of the research<br>

Chapter TWO

LITERATURE REVIEW

  • <br>
  • 2.1General overview<br>
  • 2.2Factor affecting permeability of soil<br>2.
  • 2.1Effect of grain size<br>2.
  • 2.2Effect of properties of pore fluid<br>2.
  • 2.3Effect of void ratio<br>2.
  • 3.The effect of pollution on permeability<br>

Chapter THREE

RESEARCH METHODOLOGY

  • .<br>
  • 3.1Collection of samples<br>
  • 3.2Laboratory analysis<br>3.
  • 2.1Determination of pollutal strength of effluent<br>3.
  • 2.2Determination of natural moisture content of soil<br>3.
  • 2.3Compaction test<br>3.
  • 2.4The permeability test<br>

Chapter FOUR

DATA PRESENTATION AND ANALYSIS

  • RESULT AND DISCUSSION.<br>
  • 4.1The BOD value of sewage<br>
  • 4.2The natural moisture content of the soil sample<br>
  • 4.3The optimum moisture content(OMC) of the sample<br>
  • 4.4The result of the permeability test<br>

Chapter FIVE

SUMMARY, CONCLUSION AND RECOMMENDATIONS

  • AND RECOMMENDATION.<br>CONCLUSIO<br>RECOMMENDATION<br>REFERENCES .</strong> <br></p>

Project Abstract

<p> The ignorant of the effect of sewage effluent on the permeability and other engineering properties of soil has to a level, reduced the pace of development in terms of technology.<br>The wide use of soil, irrespective of the type in virtually all civil engineering projects across the globe today has given rise to numerous researches on way of improving the properties to meet the intended use. Thus, this project examines the effect of sewage effluent contamination on the permeability of the soil.<br>Permeability is known to depend among other factors, on the void ratio and porosity of the soil sample. However, it has no effect on the affinity of the soil for water.<br>It follows that factors which increases the void ratio of a soil sample, also increases its permeability as more water is likely to pass through soil with larger voids.<br>Since sewage effluent is liquid pollution, which contains some microscopic solid particles, these particles tend to plug up pore passages and at the same time cause a decrease of permeability with time.<br>This shows that sewage effluent, although is very important to soil users in agriculture, its effect on the permeability and other engineering properties is not commendable. <br></p>

Project Overview

<p> <strong>INTRODUCTION<br>1.1. DEFINITION OF TERMS:<br>1.2.1.1.1 PERMEABILITY:</strong><br>This is the property of soil which permit flow of water through it’s inter connecting voids. Permeability is an important engineering property, which governs the rate of flow of aquifer. Hence, permeability in its simplest term is the ease with which water can flow through soil.<br><strong>1.1.2. Sewage effluent</strong><br>Sewage is the wastewater of a community consisting of human excreta, urine and sullage. Solid forms a very small percentage (0.1%) of fresh sewage. Sewage may contain pathogenic organisms, organics and nutrients. Hence, sewage must be treated before discharge in order to prevent pollution of surface and underground water source. Sewage exerts biological oxygen demand in rivers, which depletes oxygen. Besides, being rich in nutrients (mainly nitrogen and phosphorus), sewage causes in receiving water algal bloom and autrophication. Generally, supplying it with oxygen treats wastewater, so that bacteria may utilize the waste as food.<br><strong>1.1.3. Compaction:</strong><br>Compaction means processing the soil particle close to each other by mechanical methods. Air during compaction, is expelled from the void space in the soil mass and, therefore, the mass density is increased. Compaction of soil mass is done to improve its engineering properties. Compaction generally increases the shear strength of the soil, and hence the stability and bearing capacity. It is also useful in reducing the compressibility and permeability of the soil.<br>Compaction of soil is required for the construction of earth damage canal embankments, highways, runaway, and in many other engineering applications.<br><strong>1.1.4. Failure:</strong><br>Dense sand shows initially a volume decrease in a drained test, but as the strain increases, the volume starts increasing. The loose sand shows a volume decrease throughout.<br>In case of loose sand, the specimen bulges and ultimately fails by sliding simultaneously on numerous planes. The failure in this case is known as brittle failure.<br><strong>1.2 Aims and objectives</strong><br>Most ancient structures collapse, mainly due to lack of knowledge on permeability. Properties such as permeability help an engineer, to determine the suitability of soil for some engineering works.<br>Hence, modern civil engineering works allows for site investigation, which includes the determination of the permeability relative to the soil which would be used for the work.<br>The main aims of this research are.<br>· To determine the maximum dry density (MDD) of soil, thus increasing its shear strength and bearing capacity.<br>· To determine the rate of seepage of water through a given soil sample.<br>· To determine how permeability of soil is affected by sewage effluent of different levels of pollutal strength.<br><strong>1.3 Scope of the research</strong><br>This research will be carried out using soil sample, collected by digging one meter below the ground level, from a farm land located nearby the junior staff quarters. The sewage effluent will be collected from the university of Nigeria treatment tank, by varying the quantity of sewage used. <br></p>

Blazingprojects Mobile App

📚 Over 50,000 Project Materials
📱 100% Offline: No internet needed
📝 Over 98 Departments
🔍 Software coding and Machine construction
🎓 Postgraduate/Undergraduate Research works
📥 Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Electrical electroni. 4 min read

Smart Grid Demand Response Control Using Edge Analytics and Renewable Integration N...

What This Project Is About A beginner-friendly explanation of how smart grids can adjust electricity use in real time by using local data and small edge devices...

BP
Blazingprojects
Read more →
Electrical electroni. 2 min read

Smart Grid Fault Detection and Localization Using Distributed Sensor Networks...

What This Project Is About A straightforward look at how smart grids can quickly detect faults and pinpoint where they occur by using a network of small, inexpe...

BP
Blazingprojects
Read more →
Electrical electroni. 4 min read

Smart Grid Fault Detection using IoT-based Sensor Network Note: If you want more op...

What This Project Is About Develop a system that can monitor the electrical grid in real time using small sensors and internet connectivity. The project investi...

BP
Blazingprojects
Read more →
Electrical electroni. 2 min read

Smart Low-Cost IoT-Based Energy Management System for Microgrids...

What This Project Is About A plain-language overview of how small energy systems can be monitored and controlled using affordable sensors and internet tools to ...

BP
Blazingprojects
Read more →
Electrical electroni. 2 min read

Smart Grid Fault Detection and Localization using Hybrid Fuzzy-Neural Network and Ph...

What This Project Is About This project explores how a smart electrical grid can automatically detect and locate faults using a combination of fuzzy logic (huma...

BP
Blazingprojects
Read more →
Electrical electroni. 4 min read

Smart LVDC Microgrid with Real-Time Energy Management and Batteryless Solar Inverter...

What This Project Is About This project explores a small-scale, low-voltage direct current (LVDC) microgrid that can manage energy in real time. It also investi...

BP
Blazingprojects
Read more →
Electrical electroni. 3 min read

Smart Grid Demand Response using IoT and Machine Learning for Energy Optimization...

What This Project Is About A practical study that looks at how a smart electrical grid can respond to changing electricity use in real-time. It combines Interne...

BP
Blazingprojects
Read more →
Electrical electroni. 2 min read

Smart Grid Fault Detection and Isolation Using IoT and Machine Learning...

What This Project Is About A plain-language overview of how smart grids, real-time monitoring, and learning algorithms work together to detect faults in electri...

BP
Blazingprojects
Read more →
Electrical electroni. 3 min read

Smart Grid Fault Detection and Isolation Using IoT-Enabled Phasor Measurement Units ...

What This Project Is About A plain-language overview of the topic and what the project investigates. The Problem It Addresses What problem or gap this project ...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us