Extraction Of Oil From Local Seed Groundnut Seed & Characterization

 

Table Of Contents


  • Title PageApproval PageLetter Of TransmittalDedicationAcknowledgementAbstractTable Of ContentsChapter One.
  • 1.1Introduction1.2 Scope / Objectives Of The Project.Chapter Two2.0 Literature Review2.1 Groundnut Seed2.2 Adaptation2.3 Diseases Of Groundnut2.4 Extraction2.5 Methods Of Oil Extraction2.6 Rendering2.7 Mechanical Expression2.8 Solvent Extraction2.9 Groundnut Oil Extraction2.
  • 9.1Factors Affecting Rate Of Leaching2.
  • 9.2Factors Governing Choice Of Solvent2.
  • 9.3Leaching Of Vegetable Seeds2.
  • 9.4Theories Of Solvet Extractions2.
  • 9.5Undissolved Oil Theory2.
  • 9.6Physical Properties Of Vegetable Oil2.
  • 9.7Characterization Of Oils2.
  • 9.8Saponification Value2.
  • 9.9Iodine ValueChapter Three3.0 Experimental Methods3.1 Preparation Of The Seeds3.2 Particle Size Reduction
  • 3.3Extraction And Distillation3.4 Uses Of Soxlilet Extractor3.5 Distillation3.6 Solidification Point3.7 Melting Point3.8 Specific Gravity3.9 Determination Of Moisture Content3.10 Determination Of Chemical Properties3.11 Determination Of Acid Value3.12 Specification Value3.13 Peroxide Value3.14 Iodine ValueChapter Four4.0 Experimental ResultsChapter Five5.0 DiscussionChapter Six6.1 Conclusion / RecommendationReferencesAppendices.

Project Abstract

This project “Extraction of oil from a local seed (groundnut oil) and Characterization” was carried out using ten cups of groundnut seeds that was purchased from a local market in Enugu metropolis. The oil these seeds were in Enugu using solvent extraction method. Two different solvents were used in the extraction namely Ethane and order to compare their yield, physical and chemical properties.The extraction was carried out using 32og of size-reduced groundnut with 100ml of 17-hexane while 1.5litres a 15ooml of ethanol was used on 480g of size reduced groundnut seeds. Ta the end of the extraction operation, the amount of oil-extracted using17-hexane was observed to be far greater than the amount of oil extracted using ethanol.The chemical and physical properties of the oil were determined by analysis of the oil. The physical appearance of 17- hexane extract is light yellow in colour this; true colour of groundnut oil while that the ethanol extract has a light bown colour. The colour of ethanol on pigments in the size-reduced groundnut seed.From the result obtained, it was deduced that 17-hexane remains the best solvent for oil extraction while ethanol is not a good solvent for oil extraction.The physical and chemical constants/ properties determined werePHYSICAL PROPERTIESa) Solidification point.b) Melting pointc) Specific gravityd) Moisture content.CHEMICAL PROPERTIESa) Acid valueb) Specifications valuec) Peroxide valued) Iodine valueForm the analysis camied out on the extracted oil, the results obtained shows that the extracted oil is a pure groundnut oil because the iodine value which shows the purity of an oil is close to literature value. The iodine value of he oil extracted is 79.95 while the literature value (standard value) rangers from 94-102.

Project Overview

INTRODUCTION
Extraction other-wise called leaching is the preferential solution of one or more constituents of a solid mixture by contact with a liquid solvent. This unit operation, one of the oldest in the chemical industries, here been given many names, depending to some extent upon the technique used for carrying it out extraction of oil form groundnut seeds can be carried out using any of the two solid-liquid extraction methods namely: mechanical extraction method or the used of solvent other- wise called mass-transfer method. The yield of the second method is higher but contains more impurities than the first method and it requires another unit operation (distillation) in purity it better.The success of an extraction and the technique to be used will vary frequently depending upon any prior treatment which may be given to he solid. In some instance small particles of the soluble material are completely surrounded by a matrix of insoluble matter. The solvent must then diffuse into the mass, and the resulting solution must diffuse out before a separation can result. Crushing and grinding of such solids will greatly alliterate the leaching action, since then the soluble portions are made more accessible to the solvent.
Seeds like groundnut seeds and other vegetable seeds are cellular in structure, and the natural products to be leached form this material are usually found inside the cells. if the cell walls remain intact upon exposure to a suitable solvent, the leaching involves osmotic passage of the solute through the cell walls. This may be slow, but in is impractical and sometime undesirable to grind the material small enough to release the contents of individual cells.Oil constitutes a well-defined class of neutral organic substance, which are essential constituents of all forms of plant and animal life. They are soluble in other and organic solvents but not in water. Commercial oils are however from a relatively few member of the plant and animal kingdom available forms. They are primary a product of agriculture although these is also a considerably production from uncultivated tropical plants and from mature animals. Oil can be grouped into edible and non-edible depending on the amount of unspecified matters and impurities. Owing to the fact that the use of oil from crop seed as a major raw materials has increased in recent yeses their has been the need for extended and numerous research works based on the extraction of these oil. Form its seeds as economically efficiently as possible.
The only possible way of obtaining large quality of oil from oil being vegetable or plant materials is by extraction and this could best be achieve using leading process. This process can be accomplished by a variety of ways but as might be expected its efficiency depends to an extant an obtaining intimate contact between the liquid solvent and the solid containing he solute. Leaching reduces the oil content in the residue to about 0.5-1.5 percent as compared.With about 5-9 percent by mechanical process. The types of solvent available for leaching include 17-hexane, petroleum ether benzene ethyl ether etc which are high petroleum fractions. The choice of a solvent for extraction is a function of its volatility and relative volatility for easy separation by distillation.
Groundnut oil is used primary in homes for cooking and also as an industrial raw material for other usefully products.1.2 SCOPE AIMS/ OBJECTIVES OF THE PROJECT
The scope of this research project is to extract oil from groundnut seeds and compare the yields obtained using different solvents and to standard.
Also the project is aimed at characterizing the extracted oil by determining the physical and chemical properties of the oil.

Blazingprojects Mobile App

📚 Over 50,000 Project Materials
📱 100% Offline: No internet needed
📝 Over 98 Departments
🔍 Software coding and Machine construction
🎓 Postgraduate/Undergraduate Research works
📥 Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Chemical engineering. 3 min read

Optimization of biodiesel production via microwave-assisted transesterification usin...

What This Project Is About A straightforward study of producing biodiesel, a renewable fuel, using a simple chemical process guided by microwaves. The project e...

BP
Blazingprojects
Read more →
Chemical engineering. 3 min read

Hydrogen storage materials optimization using metal-organic frameworks for scalable ...

What This Project Is About A straightforward exploration of how metal-organic frameworks (MOFs) can store hydrogen more efficiently for use in on-site fuel cell...

BP
Blazingprojects
Read more →
Chemical engineering. 4 min read

Optimization of catalytic pyrolysis of plastic waste into value-added fuels and chem...

What This Project Is About A practical study on turning plastic waste into useful fuels and chemicals by using a catalytic process that speeds up reactions, com...

BP
Blazingprojects
Read more →
Chemical engineering. 2 min read

Optimizing Microbial Electrochemical Systems (MES) for Sustainable Wastewater Treatm...

What This Project Is About A final-year project that explores how to treat wastewater while producing useful energy. It looks at a technology called a microbial...

BP
Blazingprojects
Read more →
Chemical engineering. 3 min read

Modeling and Optimization of Bioreactor Performance for Sustainable Biofuel Producti...

What This Project Is About This project explores how bioreactors can be run more efficiently to produce biofuels. It combines computer simulations of fluid flow...

BP
Blazingprojects
Read more →
Chemical engineering. 2 min read

Nanomaterial-assisted CO2 capture using solid sorbents for post-combustion flue gas ...

What This Project Is About This project explores using tiny, engineered materials (nanomaterials) attached to solid substances to capture carbon dioxide from fl...

BP
Blazingprojects
Read more →
Chemical engineering. 4 min read

Development of a Waste-to-Energy Process Using Microbial Electrochemical Cells for M...

What This Project Is About A plain-language overview of the topic and what the project investigates. The Problem It Addresses What problem or gap this project...

BP
Blazingprojects
Read more →
Chemical engineering. 4 min read

Design and optimization of a biochar-based hybrid adsorption–electrochemical capac...

What This Project Is About A simple, practical exploration of using a charcoal-like material called biochar inside a device that combines adsorption (pulling dy...

BP
Blazingprojects
Read more →
Chemical engineering. 2 min read

Solar-driven Photoelectrochemical Water Splitting for On-site Hydrogen Production Us...

What This Project Is About This project explores a way to split water into hydrogen and oxygen using sunlight, with a special setup that combines two types of l...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us