Elemental analysis on pterocarpusn mildbreadii (oha) seed

 

Table Of Contents


Chapter ONE

INTRODUCTION

  • 1.1Introduction
  • 1.2Background of Study
  • 1.3Problem Statement
  • 1.4Objective of Study
  • 1.5Limitation of Study
  • 1.6Scope of Study
  • 1.7Significance of Study
  • 1.8Structure of the Research
  • 1.9Definition of Terms

Chapter TWO

LITERATURE REVIEW

  • 2.1Overview of Pterocarpus mildbreadii (Oha) Seed
  • 2.2Botanical Description
  • 2.3Traditional Uses
  • 2.4Phytochemical Composition
  • 2.5Nutritional Value
  • 2.6Medicinal Properties
  • 2.7Research on Pterocarpus mildbreadii
  • 2.8Environmental Impact
  • 2.9Economic Importance
  • 2.10Future Perspectives

Chapter THREE

RESEARCH METHODOLOGY

  • 3.1Research Design
  • 3.2Sampling Method
  • 3.3Data Collection Techniques
  • 3.4Data Analysis Procedures
  • 3.5Research Ethics
  • 3.6Research Limitations
  • 3.7Research Validity
  • 3.8Research Reliability

Chapter FOUR

DATA PRESENTATION AND ANALYSIS

  • 4.1Introduction to Findings
  • 4.2Elemental Analysis Results
  • 4.3Comparison with Existing Studies
  • 4.4Interpretation of Findings
  • 4.5Discussion on Nutritional Significance
  • 4.6Implications for Health
  • 4.7Impact on Traditional Practices
  • 4.8Recommendations for Further Research

Chapter FIVE

SUMMARY, CONCLUSION AND RECOMMENDATIONS

  • 5.1Conclusion
  • 5.2Summary of Findings
  • 5.3Contributions to Knowledge
  • 5.4Practical Implications
  • 5.5Recommendations for Application

Project Abstract

<p> Elemental analysis is the qualitative detection and quantitative determination of chemical elements(atoms,ions)in a sample(Fritz Pregl 1923). To detect an element, one should fix an appearance of an analytical signal. The formation of precipitate or characteristic crystals, colour change, an isolation of gaseous products, an appearance of a definite lines in spectrum, luminescence, etc. To determine elements quantity, it is necessary to measure a value of an analytical signal; a precipitate mass, intensity of a current, solution absorption, spectrum line, luminescence or radioactivity, a reaction rate and so on.(<a target="_blank" rel="nofollow" href="http//www.intechopen.com)">www.intechopen.com)</a>. This study was undertaken to analse the elements present in grounded Pterocarpus mildbreadii (Oha seed) using Atomic Absorption Spectrometer(AAS MODEL-AA320N).The seed was found to contain these essential macro minerals/elements sodium(Na),Potassium(K),calcium(Ca),magnesium(Mg),and the trace elements iron(Fe), copper(Cu), zinc(Zn), and selenium(Se) (Duffus,2002). The study established that Pterocarpus mildbreadii(oha seed) does not contain manganese and has high content of potassium which is necessary for good health. <br></p>

Project Overview

<p> </p><div><p><strong>1.1 INTRODUCTION</strong></p><p>A seed or mature ovule is a miniature plant with a protective cover in a suspended state of development. Most seeds contain a built-in food supply called endosperm, orchid is an exception. The endosperm can be made up of proteins, carbohydrates and fats.</p><p>Seed can also be defined as a small embryonic plant enclosed in a covering called the seed coat, usually with some stored food. It is the product of the ripened ovule of gymnosperm and angiosperm plants which occurs after fertilization and some growth within the mother plant(Wikipedia).Seed protects a plant embryo so that it can grow into a new plant. Many seeds are edible, such as sunflower seeds, tomato seeds, corn and peas.</p><p>Seeds contain three distinct structures. The inside of a seed contains an embryo, which is a baby plant with a shoot and a tiny root. The two halves of a seed are stored food that provides the nourishment necessary for seeds to germinate, or begin growing. Surrounding the seed is a hard, tough seed coat, which protects the seed during dormancy(Anville 2007).Most seeds contain a built-in food supply called endosperm. The endosperm can be made up of proteins, carbohydrates and fats. Seeds also contain anti-nutrients in their seed coat. These anti-nutrients includes phytin, lectin, trypsin inhibitor activity, tannin and cyanide.</p><p>In addition, they also contain minerals such as sodium, potassium, calcium, magnesium, phosphorus, zinc, manganese, iron, selenium and copper.(Balogun 2000)</p><p>Oilseeds are energy dense foods; for example, sesame seeds provide 600kcal or 2470kj/1000g.Although oilseeds contain protein(|14-32g/100g)and carbohydrate(ranging from less than 1g/100g to more than 34g/100g),most of the food energy they provide is as fat(which provides 9kcal or 37kj/g).Oilseeds vary widely in their fatty acid composition but tend to be rich in MUFA(e.g peanut)r PUFA(e.g sunflower seeds).Some seed oils contain significant amounts of EFA, ALNA, an n-3 fatty acid, and linoleic acid(LA),an n-6 fatty acid. from these two fatty acids, the body can make all the fatty acids it needs. From LA, arachidonic acid can be produced, and from ALNA the long chain n-3 eicosapentaenoic acid(EPA)and docosahexanoic acid(DHA)can be made.(BNF 1999).</p><p>Generally, whole oilseeds are a source of fibre, phosphorus, iron and magnesium; many oilseeds are a source of vitamin E(an antioxidant),niacin and folate. Whole oilseeds also contain phytoestrogens, a group of substances including lignans and isoflavones. Phytoestrogens have a structure similar to the oestrogen hormone oestradiol and can bind to oestrogen receptors.Phytoestrogens may provide a protective effect against coronary heart disease as they have been shown to have a lowering effect on blood cholesterol.Additionally,some phytoestrogens may have antioxidant properties(Goldberg 2003).</p><p>In Britain, oilseeds are usually consumed, following processing,as oils and margarines. The fatty acid composition of oils produced from oilseeds varies widely. Vegetable oils do not contain the same levels of macronutrients, vitamins and minerals as whole oilseeds. In fact, apart from fat itself, vitamin E is the only nutrient present in appreciable amounts. Vegetable oils do, however, contain a range of phytochemicals, e.g they are the main source of natural plant sterols in the diet. Plant sterols have a structure similar to cholesterol and hence reduce cholesterol absorption, therefore reducing the circulating levels of total and low density lipoprotein(LDL)cholesterol. Plant sterols can be present as free or esterified forms and the proportions vary, e.g free sterols dominate in soybean,olive and sunflower oil,while in rapeseed and corn oil, free sterols account for only 30% of the plant sterols.Refining vegetable oils decreases the content of sterols(from 10-70% depending on the oil and processing conditions used),thus decreasing their potential to lower serum cholesterol(Goldberg 2003).</p><p><strong>1.2 AIM OF STUDY</strong></p><p>To determine the elements present in grinded oha seed(Pterocarpus mildbreadii)</p><p><strong>1.3 RESEARCH OBJECTIVE</strong>This study was primarily designed to use grinded oha seed(Pterocarpus mildbreadii) extract for elemental analysis.</p><p><strong>CHAPTER TWO</strong><strong>LITERATURE REVIEW</strong></p><p><strong>2.1 ELEMENTAL ANALYSIS</strong>Elemental analysis is the qualitative detection and quantitative determination of chemical elements(atoms, ions)in a sample(Fritz Pregl 1923).To detect an element, one should fix an appearance of an analytical signal, the formation of precipitate or characteristic crystals, color change, an isolation of gaseous products, an appearance of a definite lines in spectrum, luminescence ,etc. To determine elements quantity, it is necessary to measure a value of an analytical signal: a precipitate mass, intensity of a current, solution absorption, spectrum line, luminescence or radioactivity, a reaction rate and so on. The content of an element is calculated on the base of a functional dependence of the analytical signal value(AS)on a mass or concentration of this element(AS=F©),which is established by calculations or experiments(Mazor L 1986).To obtain the analytical signal, chemical reactions of different types(acid-base, oxidation-reduction, complex formation),various processes(eg. precipitation)as well as different chemical, physical, biological properties of elements themselves or product of their reactions, are used. Methods for the detection and determination of elements are divided into chemical, physical, biological. The most important characteristics of these methods are the detection limit, sensitivity, selectivity,precision, rapidity and price of analysis. At present, elements are mostly detected with the help of physical methods, which are based on physical phenomena or processes eg. an interaction of elements with an energetic current. Among such methods is the method of atomic emission spectroscopy(AES),based on a thermal excitation of atoms of free elements and registration of the optic spectrum of excited atoms emission (Kellner R.et al. 1998).</p><p></p></div><h3></h3><br> <br><p></p>

Blazingprojects Mobile App

๐Ÿ“š Over 50,000 Project Materials
๐Ÿ“ฑ 100% Offline: No internet needed
๐Ÿ“ Over 98 Departments
๐Ÿ” Software coding and Machine construction
๐ŸŽ“ Postgraduate/Undergraduate Research works
๐Ÿ“ฅ Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Biochemistry. 2 min read

Development of a CRISPR-based biosensor for rapid detection of antibiotic resistance...

What This Project Is About A straightforward study of a biosensor that uses CRISPR technology in a cell-free system to detect antibiotic resistance genes found ...

BP
Blazingprojects
Read more →
Biochemistry. 4 min read

Engineering of enzymatic cascades for selective biomass-derived chemical synthesis: ...

What This Project Is About The project explores how a sequence of enzymatic reactionsโ€”an enzymatic cascadeโ€”can be designed to transform inexpensive, plant-b...

BP
Blazingprojects
Read more →
Biochemistry. 4 min read

Development of a CRISPR-based diagnostic platform for rapid detection of antimicrobi...

What This Project Is About A straightforward introduction to using a gene-editingโ€“inspired tool (Cas12a) to detect antibiotic resistance genes quickly at the ...

BP
Blazingprojects
Read more →
Biochemistry. 2 min read

Development and optimization of CRISPR-based STRIP-tag system for real-time visualiz...

What This Project Is About The project looks at a way to watch how lipid metabolism enzymes work inside living cells. It uses a genome-editing tool to tag enzym...

BP
Blazingprojects
Read more →
Biochemistry. 2 min read

Characterization of novel plant-derived polyphenols as modulators of mitochondrial b...

What This Project Is About A straightforward, non-technical look at how certain plant-based polyphenols might affect how cancer cells produce and use energy ins...

BP
Blazingprojects
Read more →
Biochemistry. 2 min read

Design, synthesis, and functional characterization of a novel biosynthetic pathway f...

What This Project Is About A straightforward look at how scientists can design and test a new biological pathway in bacteria to make more of a useful metabolite...

BP
Blazingprojects
Read more →
Biochemistry. 4 min read

Development of a label-free, rapid biosensor for early detection of metabolic syndro...

What This Project Is About The project explores a simple, fast way to detect early signs of metabolic syndrome in people using a tiny sensor. The sensor can rea...

BP
Blazingprojects
Read more →
Biochemistry. 2 min read

Characterization of plant-based polyphenolic proteins and their role in modulating o...

What This Project Is About A plain-language overview of plant-based proteins and how they might affect cellular stress in human cells. The project looks at whic...

BP
Blazingprojects
Read more →
Biochemistry. 4 min read

Metabolomic profiling of sacaride-conjugated bile acids in non-alcoholic fatty liver...

What This Project Is About The project looks at small molecules called bile acids and how they are chemically linked to sugars (sacarides) in people with non-al...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us