Home / Medical Laboratory Science / Effect of steeping period on yield and acceptability of starch extracted from sorghum

Effect of steeping period on yield and acceptability of starch extracted from sorghum

 

Table Of Contents


<p> </p><p><strong>

Chapter ONE

</strong></p><p>1.0 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Introduction</p><p>1.1 &nbsp; &nbsp; &nbsp; Statement of Problem</p><p>1.2 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Objectives of the Study</p><p><strong>

Chapter TWO

</strong></p><p>2.0 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Literature Review</p><p>2.1 &nbsp; &nbsp; &nbsp; Origin of Sorghum</p><p>2.2 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Structure of Sorghum</p><p>2.3 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Nutritive Value</p><p>2.4 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Uses and Method of Preparation</p><p>2.5 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Limitation / Toxicity</p><p>2.6 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Processing of Sorghum for Starch</p><p>2.7 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Starches</p><p>2.7.1 &nbsp; &nbsp; &nbsp; &nbsp;Definition</p><p>2.7.2 &nbsp; &nbsp; &nbsp; &nbsp;Forms / Structures / Derivatives</p><p>2.7.3 &nbsp; &nbsp; &nbsp; &nbsp;Reactions of Starch in Food Systems</p><p>2.7.4 &nbsp; &nbsp; &nbsp; &nbsp;Food Uses of Starch and their Functional Properties</p><p>2.7.5 &nbsp; &nbsp; &nbsp; &nbsp;Spoilage of Starches</p><p><strong>

Chapter THREE

</strong></p><p>3.0 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Materials and Method</p><p>3.1 &nbsp; &nbsp; &nbsp; Source of Raw Material</p><p>3.2 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Method of Production</p><p>3.3 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Analysis of Some Functional Properties</p><p>3.3.1 &nbsp; &nbsp; &nbsp; &nbsp;Determination of Yield</p><p>3.3.2 &nbsp; &nbsp; &nbsp; &nbsp;Bulk Density</p><p>3.3.3 &nbsp; &nbsp; &nbsp; &nbsp;Syneresis</p><p>3.3.4 &nbsp; &nbsp; &nbsp; &nbsp;Swelling Capacity</p><p>3.3.5 &nbsp; &nbsp; &nbsp; &nbsp;Gelation Temperature</p><p>3.3.6 &nbsp; &nbsp; &nbsp; &nbsp;Least Gelation Concentration</p><p>3.4 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Metabolisable Energy Value</p><p>3.5 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Glycosidic Cyanide Content</p><p>3.6 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Moisture Content</p><p>3.7 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Sensory Evaluation</p><p><strong>

Chapter FOUR

</strong></p><p>4.0 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Results / Discussion</p><p>4.1 &nbsp; &nbsp; &nbsp; Results</p><p>4.2 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Discussion</p><p><strong>

Chapter FIVE

</strong></p><p>5.0 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;Conclusion and Recommendation</p><p>References</p><p>Appendix</p> <br><p></p>

Project Abstract

<p> Starch was extracted from two varieties of sorghum bicolor grains (white and red varieties) steeped for 6, 8 and 12 hours by wet milling method, the starch samples were analysed for yield, functional properties and overall acceptability. The yield of the white variety ranged from 0.45 – 0.70kg and the red variety was 0.40 – 0.50kg. The result of their functional properties were as follows; Bulk density, white (0.700 – 0.733g/ml), red (0.723 – 0.753g/ml) Gelation temperature; white (70 – 72oc) red (73 – 74oc). Least gelation concentration; white (0.60 – 0.90g/10ml), red (0.70 – 1.00g/10ml). Metabolisable energy value, white (3.12 –3.82kcal/g), red (3.73 – 3.82 kcal.g). Glycosidic cyanide content, white (4.5 – 8.5%), red (8.5 – 10.5%). The starchy samples with shorter steeping periods gave better results in terms of functional properties, metabolisable energy value, and percentage moisture content. The starch samples steeped for longer periods had greater yield but poorer functional properties. The white variety tested cyanide free and had better results than the red variety. The result of the sensory evaluation revealed that the samples had significant difference at p(0.05) and p(0.01) in colour and consistency. But there was no significant difference at p(0.05) and p(0.01) in flavour, texture and overall acceptability <br></p>

Project Overview

<p> </p><p><strong>1.0 &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;</strong><strong>INTRODUCTION</strong></p><p>Starch is non-crystalline white powder, insoluble in cold water.</p><p>It can be hydrolysed into simpler molecules by either heating with an acid or a suitable enzyme. (Awan and Okaka, 1983).</p><p>Starch is the major storage form of carbohydrate in sorghum and millets. It consists of amylopectin, a branched – chain polymer of glucose, and amylose, a straight chain polymer (FAO, 1992).</p><p>The digestibility of the starch, which depends on hydrolysis by pancreatic enzymes, determines the available energy content of cereal grain. Processing of the grain by methods such as steaming, pressure cooking, flaking, puffing or Micronesian of the starch increases the digestibility of sorghum starch.</p><p>This has been attributed to a release of starch granules from the protein matrix rendering t hem more susceptible to enzymatic digestion (FAO, 1992).</p><p>When starch is heated in water (moist heat) it will produce a gel – an important property needed in the thickening of gravies, sauces, in the baking of bread and production of custards (Awan and Okaka, 1983).</p><p>The physico-chemical properties of the starch affect the textural characteristics of the food preparations made from the grain.</p><p>The behaviour of starch in water is temperature and concentration dependent (Malleshi and Desikachar, 1985).</p><p>Starches in general show very little uptake of water at room temperature and their swelling power is so small. At higher temperature, water uptake increases and starch granules collap— which leads to solubilisaiton of amylose and amylopectin to form a colloidal solution. This is the gelatinisation stage. Genetic and environmental factors affect the gelatinisation temperature of starch (Freeman and Bocan, 1973).</p><p>Heat treatment of starch in a limited amount of water lead to swelling the granules with very little loss of soluble material and partial gelatinization of the starch (Watson, 1970).</p><p>On cooking, the gelatinized starch tends to return from the soluble, dispersed and amorphous state to an insoluble crystalline state.</p><p>This phenomenon is known as retrogradation or set back; it is enhanced with low temperature and high concentration of starch (Rooney, 1991). Amylose, the linear component of the starch, is more susceptible to retrogradatioln than the amylopectin (Freeman and Bocan, 1973).</p><p><strong>1.1 &nbsp; &nbsp; &nbsp; STATEMENT OF THE PROBLEM</strong></p><p>Steeping of sorghum for a longer period consumes time and imparts undesirable flavour to the starch extracted from the sorghum due to the action of some spoilage microorganisms. Hence the need to reduced the steeping time and detect its effect on the yield and their sensory properties.</p><p>1.2 &nbsp; &nbsp; &nbsp; The overall objective of the project work is to develop a process for extracting starch from two different cultivar of sorghum by subjecting to different steeping time.</p><p>The null hypothesis is that cultivar and steeping period will not have effect on the yield and functionality of the extracted starch.</p><p>Specific aims are:</p><p>To determine the effect of steeping period on:</p><p>1. &nbsp; &nbsp; &nbsp; &nbsp; The yield of the starch</p><p>2. &nbsp; &nbsp; &nbsp; &nbsp; The functional properties of the starch</p><p>3. &nbsp; &nbsp; &nbsp; &nbsp; Organoleptic properties of the starch</p><p>4. &nbsp; &nbsp; &nbsp; &nbsp; The glycosidic cyanide level of the starch</p><p>5. &nbsp; &nbsp; &nbsp; &nbsp; The metabolysable energy value of the starch</p> <br><p></p>

Blazingprojects Mobile App

📚 Over 50,000 Project Materials
📱 100% Offline: No internet needed
📝 Over 98 Departments
🔍 Project Journal Publishing
🎓 Undergraduate/Postgraduate
📥 Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Medical Laboratory S. 4 min read

Utilization of Artificial Intelligence in Blood Transfusion Medicine: A Comparative ...

The project "Utilization of Artificial Intelligence in Blood Transfusion Medicine: A Comparative Analysis of Traditional Methods vs. Machine Learning Algor...

BP
Blazingprojects
Read more →
Medical Laboratory S. 2 min read

Development of a Rapid Diagnostic Test for Emerging Infectious Diseases...

The project titled "Development of a Rapid Diagnostic Test for Emerging Infectious Diseases" aims to address the urgent need for efficient and timely ...

BP
Blazingprojects
Read more →
Medical Laboratory S. 2 min read

The Impact of Rapid Diagnostic Tests on the Detection and Management of Infectious D...

The project topic focuses on exploring the implications of rapid diagnostic tests for the detection and management of infectious diseases in resource-limited se...

BP
Blazingprojects
Read more →
Medical Laboratory S. 3 min read

Utilization of Artificial Intelligence in Hematology for Automated Blood Cell Morpho...

The project on "Utilization of Artificial Intelligence in Hematology for Automated Blood Cell Morphology Analysis" aims to explore the integration of ...

BP
Blazingprojects
Read more →
Medical Laboratory S. 4 min read

Development of a Rapid Diagnostic Test for Infectious Diseases...

The project "Development of a Rapid Diagnostic Test for Infectious Diseases" focuses on addressing the critical need for efficient and accurate diagno...

BP
Blazingprojects
Read more →
Medical Laboratory S. 2 min read

Implementation of Point-of-Care Testing in Rural Healthcare Settings: A Cost-Effecti...

The project topic "Implementation of Point-of-Care Testing in Rural Healthcare Settings: A Cost-Effectiveness Analysis" focuses on the utilization of ...

BP
Blazingprojects
Read more →
Medical Laboratory S. 3 min read

Application of Artificial Intelligence in Diagnosing Infectious Diseases in Clinical...

The project topic, "Application of Artificial Intelligence in Diagnosing Infectious Diseases in Clinical Microbiology," focuses on the integration of ...

BP
Blazingprojects
Read more →
Medical Laboratory S. 3 min read

Application of Molecular Techniques in Diagnosis and Management of Infectious Diseas...

The project topic "Application of Molecular Techniques in Diagnosis and Management of Infectious Diseases in Clinical Microbiology" focuses on the uti...

BP
Blazingprojects
Read more →
Medical Laboratory S. 2 min read

Implementation of Molecular Techniques in the Diagnosis of Infectious Diseases...

The research project on "Implementation of Molecular Techniques in the Diagnosis of Infectious Diseases" aims to explore and evaluate the application ...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us