Home / Mechanical engineering / Comparative study of disinfectant efficiency of ethanol, bleach and phenolics against pseudomonas aeruginosa and staphylococcus aureus

Comparative study of disinfectant efficiency of ethanol, bleach and phenolics against pseudomonas aeruginosa and staphylococcus aureus

 

Table Of Contents


Project Abstract

<p> Ethanol, Bleach and Phenolics are three kinds of disinfectants which have been widely used in common laboratories. &nbsp;In this study, a compared experiment on these three disinfectants efficiency was conducted against <em>Staphylococcus aureus and Pseudomonas aeruginosa</em>&nbsp;using agar hole diffusion method. Different concentrations of bleach (1%, 2%, 3%, 4% and 5%) were used on both organisms. &nbsp;Also (50%, 60%, 70%, 85% and 95%) of ethanol as well as (5%, 10%, 20%, 25%, and 30%) Phenolics were used. Diffrences in &nbsp;concentrations tested was because, the original concentrations of the disinfectants differs. After 24 hours of incubation at 370C, the results showed that all the disinfectants inhibited the growth of the test organism in their concentrated forms. &nbsp;The diameter of zone of inhibitions were measured around each well by using a ruler in millimeters, using different concentrations, their efficacies varied. &nbsp;The results showed that 30% Phenolics had the best efficiency against both test organisms and 5% bleach had a better effect on <em>Staphylococcus aureus</em>&nbsp;than <em>Pseudomonas aeruginosa</em>, while ethanol showed least sensitivity. 70% concentration gave the highest effect on <em>Staphylococcus aureus</em>&nbsp;as compared with<em>Pseudomonas aeruginosa.</em> <br></p>

Project Overview

<p> </p><p>1.0 &nbsp; &nbsp; &nbsp; INTRODUCTION</p><p>&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; Microorganisms are minute living things that individually are too small to be seen with the unaided eyes (Tortora <em>et al</em>, 2007). &nbsp;Though only a minority of microorganisms are pathogenic (disease producing), practical knowledge of microbes is necessary for medicine and related health sciences. &nbsp;For example hospital workers must be able to protect patients from common microbes that are normally harmless but pose a threat to the sick and injured. &nbsp;Thousands of people died in devastating epidemics; the cause of which was not understood. &nbsp;Entire families died because vaccination and antibiotics were not available to fight infection (Johnson and Case, 1995). &nbsp;This leads to scientific control of microbial growth. &nbsp;This began only about 100 years ago. &nbsp;It was Pasteur’s work on microorganism that led scientists to believe that microbes were a possible cause of diseases and need to be eliminated or destroyed. &nbsp;Some examples off these microbes are; Bacteria, fungi, viruses and protozoa etc (Tortora et al, 2007).</p> <br><p></p>

Blazingprojects Mobile App

📚 Over 50,000 Project Materials
📱 100% Offline: No internet needed
📝 Over 98 Departments
🔍 Project Journal Publishing
🎓 Undergraduate/Postgraduate
📥 Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Mechanical engineeri. 4 min read

Design and analysis of a solar-powered desalination system for remote communities....

The project "Design and Analysis of a Solar-Powered Desalination System for Remote Communities" aims to address the pressing need for sustainable acce...

BP
Blazingprojects
Read more →
Mechanical engineeri. 2 min read

Design and Optimization of a Solar-Powered Refrigeration System...

The project topic, "Design and Optimization of a Solar-Powered Refrigeration System," focuses on the development of an innovative and sustainable cool...

BP
Blazingprojects
Read more →
Mechanical engineeri. 3 min read

Design and Optimization of a Fuel-Efficient Hybrid Electric Vehicle Powertrain...

The project on the "Design and Optimization of a Fuel-Efficient Hybrid Electric Vehicle Powertrain" aims to address the pressing need for sustainable ...

BP
Blazingprojects
Read more →
Mechanical engineeri. 4 min read

Design and development of an energy-efficient wind turbine for urban applications...

The project "Design and development of an energy-efficient wind turbine for urban applications" aims to address the growing need for sustainable energ...

BP
Blazingprojects
Read more →
Mechanical engineeri. 2 min read

Design and optimization of a novel energy-efficient HVAC system for commercial build...

The project topic, "Design and optimization of a novel energy-efficient HVAC system for commercial buildings," focuses on addressing the growing need ...

BP
Blazingprojects
Read more →
Mechanical engineeri. 4 min read

Design and analysis of an energy-efficient hydraulic system for industrial applicati...

The project on "Design and Analysis of an Energy-Efficient Hydraulic System for Industrial Applications" aims to address the growing need for sustaina...

BP
Blazingprojects
Read more →
Mechanical engineeri. 2 min read

Design and Development of an Automated Robotic Arm for Industrial Applications...

The project topic, "Design and Development of an Automated Robotic Arm for Industrial Applications," focuses on the innovative integration of robotics...

BP
Blazingprojects
Read more →
Mechanical engineeri. 2 min read

Design and optimization of an energy-efficient hybrid vehicle powertrain....

The project on "Design and optimization of an energy-efficient hybrid vehicle powertrain" focuses on addressing the growing need for sustainable trans...

BP
Blazingprojects
Read more →
Mechanical engineeri. 3 min read

Design and Optimization of a Solar-Powered Cooling System for Automotive Application...

The project "Design and Optimization of a Solar-Powered Cooling System for Automotive Applications" focuses on the development of an innovative coolin...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us