Project Abstract

This is the presentation of an information on the structural reinforcement detailing of concrete members. Structural detailing is a branch of structural work that transposes the idea or works of a structural engineer into working drawing or easy utilization in the building construction works. Working drawing are produced an engineer for easy use by the contractors.

The processes detailing put in place was in conjunction with the recommendations of the concrete society and the institute of structural engineers. In building construction a good interaction and contractors are required. The methods, scates, symbols and notations must be standardized and understood by all parties in a project to minimize risks and communication hindrances.

A structure is broken down into identifiable elements for detailing work like bean column, slab etc which enables the different detailing aspects to be fully addressed and understood.

STRUCTURAL SYMBOLS

The abbreviations recommended for structural detailing work are a s follows.
a. R.C. – Reinforced concrete
drg – drawing
hor – horizontal
vest – vertical
dia – diameter
fdn – fordation
conc – concrete
col – column
b. Type of reinforcement
R – Mild steel bars
Y – High yield bars
c. Comments relating to reinforcement
C – center line
B – Bottom
T – Top
c/c – center to centre
TABLE OF CONTENT
CHAPTER ONE
INTRODUCTION
CHAPTER TWO
Detailing processes
Reinforcement sizes Notation of drawing Bar bending schedule Types of drawing Margins and panels
Thickness of line, lettering and spelling
Dimensions
Scales
CHAPTER THREE
REINFORCED CONCRETE
CHAPTER THREE
REINFORCED CONCRETE
CHAPTER FIVE
Detailing of the elements foundation
Staircase
Retaining wall
Bibliography

Project Overview

INTRODUCTION

Before a designer can relate his requirements dearly in a construction industry, a drawing is to be prepared; this is because the drawing serves as a general means of communication. Thus, the drawing is adopted mostly, then other means of communication in engineering sectors.

A structured engineer mostly engages himself in designs on construction of structures. Like roads, bridges, railways, dams, buildings and other public works.

The structural engineer makes initial designs, which are usually free – hand sketches of the work. These sketches are used to make clear and neat working drawing, which will b e used by the builder of contractor after approval for construction by the authorities involved.

The contributions of a detailer is highly significant to the construction process, for a well detailed drawing is a good medium of reducing the risks of building collapses and to avoid delays arising from doubts and too frequent clarifications.

This project shows the methods and techniques needed for detailing of reinforced concrete structures.