falling head permeabili">  falling head permeabili">
Home / Civil engineering / CONSTRUCTION OF FALLING HEAD PERMEAMETER AND DETERMINATION OF THE PERMEABILITY COEFFICIENT OF SANDY AND LATERITIC SOIL IN KHANA

CONSTRUCTION OF FALLING HEAD PERMEAMETER AND DETERMINATION OF THE PERMEABILITY COEFFICIENT OF SANDY AND LATERITIC SOIL IN KHANA

 

Table Of Contents


Chapter ONE

1.1 Introduction
1.2 Background of study
1.3 Problem Statement
1.4 Objective of study
1.5 Limitation of study
1.6 Scope of study
1.7 Significance of study
1.8 Structure of the research
1.9 Definition of terms

Chapter TWO

2.1 Overview of Permeability
2.2 Types of Permeameters
2.3 Permeability of Sandy Soil
2.4 Permeability of Lateritic Soil
2.5 Factors Affecting Permeability
2.6 Previous Studies on Permeability
2.7 Measurement Techniques for Permeability
2.8 Theoretical Frameworks on Permeability
2.9 Permeability Coefficient Calculations
2.10 Recent Developments in Permeability Testing

Chapter THREE

3.1 Research Design
3.2 Sampling Methods
3.3 Data Collection Procedures
3.4 Experimental Setup
3.5 Data Analysis Techniques
3.6 Validity and Reliability
3.7 Ethical Considerations
3.8 Limitations of Research Methodology

Chapter FOUR

4.1 Analysis of Experimental Results
4.2 Comparison of Permeability Coefficients
4.3 Influence of Soil Type on Permeability
4.4 Discussion on Factors Impacting Permeability
4.5 Interpretation of Findings
4.6 Practical Implications of Results
4.7 Recommendations for Future Research
4.8 Conclusion of Findings

Chapter FIVE

5.1 Summary of Research
5.2 Conclusions Drawn
5.3 Contributions to Knowledge
5.4 Implications for Practice
5.5 Recommendations for Further Study

Project Abstract

The permeability coefficient of sandy and lateritic soil was carried out. In this work, falling head permeability test, sieve analysis, moisture content and Atterberg limit tests were performed on the soil samples collected from 5 different communities in Khana L.G.A of Rivers State. Experimental permeability coefficients of the soil was determined using falling head permeability test. The result of the falling head permeability test revealed that the permeability coefficient of laterite soil in Khana ranges from 0.005 – 0.073cm/s and that of sandy soil ranges from 0.113 – 0.929cm/s. The for laterite and sand is approximately 0.12mm.



Project Overview

1.1 BACKGROUND OF STUDY

A certain number of problems relating to the interacting factor of soils had been the major concern of geotechnical engineers over the years. This is because the engineering properties of soils exhibits varying and uncertain behaviors, due to the complex and imprecise physical process associated with the formation of these materials which is a matter of concern for geotechnical engineers. Amongst the many interacting factors of the soil that the engineer has to deal with, permeability is one of its very important engineering properties (Whiteman, 1969) This reason is attributed to the fact that it plays a predominant role in solving of a good number of engineering problems such as settlement of buildings, yield of wells, seepage through and below the earth structures; it also controls the hydraulic stability of soil masses. It is important to note the permeability of soils is influenced by various factors such as particle size, structure of soils, shape of particles, void ratio, properties of water and degree of saturation (Handsbo, 1994). Furthermore, it is needful to mention that several methods can be adopted in the determination of the coefficient of permeability in the field and laboratory generally depending on the site conditions and type of soil. Other research works have been carried out to relate permeability and compaction characteristics of soils to their physical properties: Rowan and Graham (1948) used gradation, specific gravity, and shrinkage limit in their correlation equations, Davidson and Gardiner (1949) eliminated the specific gravity from the equations of Rowan and Graham (1948), but included a plasticity index.Taylor (1948) formulated a theoretical equation, based on the capillary tube model, for flow through porous media, relating the permeability with a representative grain size etc. The physical properties used generally include plasticity characteristics (liquid limit, plastic limit, shrinkage limit, and plasticity index), specific gravity, and grain size distribution that are attainable from relatively straightforward laboratory tests. However, specific index properties used in various correlation equations differ considerably. To ascertain the permeability coefficient of the soil, soil samples are to be collected and taken to the laboratory to carry out the above mention practical. For the purpose of this work, various soil samples have been collected from various locations within the study area to determine the permeability coefficient of the study area.

1.2 STATEMENT OF PROBLEM

Soil permeability is a key test for the determination of infiltration capacity of any soil. It aids the engineers to effectively control flooding in an area. Permeability coefficient also aids soil classification, dam design, filter construction, slope stability analysis and drainage design. This work is aimed at determining the permeability coefficient of sandy and lateritic soil in Khana Local Government area.

1.3 OBJECTIVES OF STUDY

The aim of this study is to determine the permeability coefficient of sandy and lateritic soil in Khana Local Government Area. The specific objectives of the study are: i. Determine the permeability coefficient of sandy and lateritic soil in Khana ii. To determine the coefficient of uniformity (Cu) for sandy and lateritic soil in Khana iii. To determine the Plastic and the Liquid limit values for Khana soil.


Blazingprojects Mobile App

📚 Over 50,000 Project Materials
📱 100% Offline: No internet needed
📝 Over 98 Departments
🔍 Software coding and Machine construction
🎓 Postgraduate/Undergraduate Research works
📥 Instant Whatsapp/Email Delivery

Blazingprojects App

Related Research

Civil engineering. 4 min read

Design and Analysis of a Sustainable High-rise Building Using Green Construction Tec...

The project topic "Design and Analysis of a Sustainable High-rise Building Using Green Construction Techniques" focuses on the innovative approach of ...

BP
Blazingprojects
Read more →
Civil engineering. 4 min read

Analysis and Design of Sustainable Green Building Structures using Bamboo as a Prima...

The project on "Analysis and Design of Sustainable Green Building Structures using Bamboo as a Primary Material" aims to explore the feasibility and b...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Analysis and design of a sustainable stormwater management system for urban areas....

The project topic, "Analysis and design of a sustainable stormwater management system for urban areas," addresses the critical need for effective stor...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Optimization of Reinforced Concrete Bridge Design for Enhanced Durability...

The project topic "Optimization of Reinforced Concrete Bridge Design for Enhanced Durability" focuses on improving the longevity and resilience of rei...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Optimization of Reinforced Concrete Structures Using Advanced Computational Tools...

The project on "Optimization of Reinforced Concrete Structures Using Advanced Computational Tools" aims to enhance the design and analysis process of ...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Design and Analysis of a Sustainable Urban Drainage System...

The project on "Design and Analysis of a Sustainable Urban Drainage System" aims to address the critical issue of urban drainage in modern cities. Urb...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Enhancing the Durability of Concrete Structures through the Application of Advanced ...

The project topic, "Enhancing the Durability of Concrete Structures through the Application of Advanced Materials," focuses on improving the longevity...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Analysis and Design of Sustainable Low-Carbon Building Materials for High-Rise Const...

The research project titled "Analysis and Design of Sustainable Low-Carbon Building Materials for High-Rise Construction" aims to address the growing ...

BP
Blazingprojects
Read more →
Civil engineering. 3 min read

Optimization of Concrete Mix Designs for Sustainable Construction Practices...

The project titled "Optimization of Concrete Mix Designs for Sustainable Construction Practices" aims to address the growing need for environmentally ...

BP
Blazingprojects
Read more →
WhatsApp Click here to chat with us