Thesis Abstract

<p>                     <b>ABSTRACT&nbsp;</b><br></p><p> This paper presents the design, construction and performance evaluation of solar drying for maize, the solar drying system consists of V-groove collector of 2.04 m² area, drying chamber and blower. It was designed in such a way that solar radiation is not incident directly on the maize. K-type thermocouples were used for temperature measurement, while solar radiation was measured by solar meter m od.776. The thermal energy and heat losses from solar collector were calculated for each three tilt angles (30º, 45º, 60º). The results obtained during the test period denoted that the maximum gained energy occurred at 11 o'clock hour and then gradually declined since the maximum solar radiation occurred at this time. The performance of the solar drying system was highly dependent on the solar radiation, tilt angle and ambient temperature. The total loss factor of the collector increases with the increase in the intensity of solar radiation intensity. The theoretical thermal energy, the experimental actual heats gain increase by increasing radiation intensity. Key words Solar energy, solar air collector, v-corrugated collector, solar drying system performance study <br></p>

Thesis Overview

<p><b>1.1 INTRODUCTION&nbsp;</b></p><p>In many parts of the world there is a growing awareness that renewable energy have an important role to play in extending technology to the farmer in developing countries to increase their productivity (Waewsak et al., 2006). Solar thermal technology is a technology that is rapidly gaining acceptance as an energy saving measure in agriculture application. It is preferred to other alternative sources of energy such as wind and shale, because it is abundant, inexhaustible and non-polluting, wind (Akinola, 1999; Akinola and Fapetu, 2006; Akinola et al., 2006). Solar air heaters are simple devices to heat air by utilizing solar energy and it is employed in many applications requiring low to moderate temperature below 80°C, such as crop drying and space heating (Kurtbas and Turgut, 2006). They are defined as a process of moisture removal due to simultaneous heat and mass transfer (Ertekin and Yaldiz, 2004). According to Ikejiofor (1985) two types of water are present in food items; the chemically bound water and the physically held water. In drying, it is only the physically held water that is removed. The most important reasons for the popularity of dried products are longer shelf-life, product diversity as well as substantial volume reduction. This could be expanded further with improvements in product quality and process applications. The application of dryers in developing countries can reduce post harvest losses and significantly contribute to the availability of food in these countries. Estimations of these losses are generally cited to be of the order of 40% but they can, under very adverse conditions, be nearly as high as 80%. A significant percentage of these losses are related to improper and/or untimely drying of foodstuffs such as cereal grains, pulses, tubers, meat, fish, etc. (Bassey, 1989; Togrul and Pehlivan, 2004). Traditional drying, which is frequently done on the ground in the open air, is the most widespread method used in developing countries because it is the simplest and cheapest method of conserving foodstuffs. Some disadvantages of open air drying are: exposure of the foodstuff to rain and dust; uncontrolled drying; exposure to direct sunlight which is undesirable for some foodstuffs; infestation by insects; effect by animals; etc (Madhlopa et al., 2002). Solar drying may be classified into direct, indirect and mixed-modes. In direct solar dryers the air heater contains the grains and solar energy passes through a transparent cover and is absorbed by the grains. Essentially, the heat required for drying is provided by radiation to the upper layers and subsequent&nbsp; conduction into the grain bed. In indirect dryers, solar energy is collected in a separate solar collector (air heater) and the heated air then passes through the grain bed, while in the mixedmode type of dryer, the heated air from a separate solar collector is passed through a grain bed and at the same time, the drying cabinet absorbs solar energy directly through the transparent walls or roof. Therefore, the objective of this study is to develop a mixed-mode solar dryer in which the grains are dried simultaneously by both direct radiation through the transparent walls and roof of the cabinet and by the heated air from the solar collector. The performance of the dryer was also evaluated. <br></p>